I have been trying to custom scan 35mm slides at 16bit w/ Resolution input & output each set at 800dpi, and image size approximately 8"w x 5"h. I have gone into the "Custom Wizard" and finally been able to set 800pi for both input and output, but the size won't go higher than Input & Output W1.46 x H.97 (inch setting) - which is just tiny! If I go higher on the inches, the Resolution input resets itself to 3200dpi, and the output width in inches won't even go above 5.85 anyway. It's like trying to fit down the alternate corners of a too-tight fitted sheet on a mattress - you get one down and the other one pops up.
Anybody know how to override all of the settings and make your own custom adjustments?
Thank you so much!
margaret in brooklyn